Access Control : Installing and using ScanMan module : Configuration : Setting .INI settings
 
Setting .INI settings
 
While some settings can be changed on the Config dialog of ScanMan module, not all can. However, all .INI settings can be set by scanning an appropriate barcode. This must be done outside of the startup setting of Location and Operator. The following table shows key ScanMan configuration barcodes.
Multiple ScanMan.INI settings by stringing together commands in the following format: SETOPMATT;SETLOC1;SETPIC1. ;SET is necessary for the commands following the first to be read.
 
ScanMan configuration barcode
Purpose
SETIPx
Sets the IP address (e.g., SETIP127.0.0.1)
SETPORTx
Sets the port
SETTDx
Sets the trickle delay (tenths of a second)
SETTIx
Sets the trickle interval (tenths of a second)
SETTOx
Sets the time out (tenths of a second)
SETIDx
Sets the Unit ID
SETROLLx
Sets the rollover month
The exceptions are LOC and OP. While SETLOCxxxxxx and SETOPxxxxxx always set the location and operator, respectively, it’s possible to use LOCxxxxxxx and OPxxxxxx. However, please see the section on LocOp, as this can change the behavior.